Quantities are limited. No one else has these, be the first!
New with Detailed
instructions, wire tie to make your installation
neat
The
Direct Cord with RED & BLUE LEDs is a unique power cord with a
Red power LED and a
Blue alert LED to place within view.
Our instructions are very detailed
and installation is very simple.
We usually ship the same day so you get your
order with lightning fast shipping!
|
What is
a Direct Cord with
Red power LED and a Blue alert LED? |
The
Direct Cord with RED & BLUE LEDs
is an optional accessory that allows you to connect your radar detector directly
to your fuse block or other 12-volt source and provides
a Red power LED and a Blue alert LED to place within eye view.
The
Direct Cord with RED &
BLUE LEDs
is approximately 5 feet long, with the
Red power LED on a cord that about 3
feet long and
Blue alert LED on a
separate cord that about 3 feet long connected at the built-in
FUSED
end of the cord so you can place it within view.
The
power L.E.D. turns on when your radar
detector is on, turns off when your radar detector is off.
The
alert L.E.D. blinks when in alert mode
and is off when not in use.
It's the perfect addition for any
motorcycle when hearing the radar detector is not possible.
Now you can see the alert as it flashes in alert mode.
Normally comes
with a T - Tap
to connect to a power wire source.
If you need a Fuse tap, just let us know which one you
would like and we'll replace the T-Tap in your order.
1. Blade Fuse
Tap
to connect to a blade fuse
in the fuse box, or a
2. Mini Blade Fuse
Tap
to connect to a mini blade
fuse in the fuse box.
Now you can
wire directly to your fuse box or power wire source and eliminate dangling power
cords.
Our power cords will allow your
radar detector to be hard wired to your motorcycle very easily.
You can simply unplug the red wire from the T-tap
connector or Fuse Tap, and unhook the black ground wire if you ever decide to
remove it.
